Discussion Locked

No domain server was available to valida

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have a network of 35 users with most of them using Windows 95. Every time one of the users shuts down their workstation and restarts they get the message "No domain server was available to validate your password...", the message is a little different on NT machines. The users have to keep trying to login until the server finally responds. We have a PDC, a BDC and an Email server all running NT4 with service pack 6a. We also run on DHCP. Sometimes a user cannnot login until they renew iprelease and renew ip addresses. I have tried setting static ip's for some machines and also extending the lease on them, but it has not worked. I have read the problem could be related to the LMHOSTS file, but we do not use it here. Help!

Thanks in Advance.

7 replies

by packerdawg

I ran into this problem and had to add an lmhosts file. Use the below format for domain controller entry:

xx.xx.xx.xx pdcname #PRE#DOM:domainname
xx.xx.xx.xx "domainname\0x1babcde" #PRE

notes:
xx.xx.xx.xx = ip address of pdc
domainname = your domain name
number of characters between " " must be 20, use area after the \ to fill in remaining spaces after your domain name.

by bkduke

If you are running in a switched ethernet environment on Cisco Catalyst switches it is possible that you do not have set spantree portfast enable for the ports your users are on. By default the Cisco Catalyst switches enable Spanning Tree Protocol to prevent layer 2 loops when using multiple switches. When a port becomes active by turning on the attached device, the switch waits a period of time to make certain it does not setup multiple paths to the port. This causes a delay in the availability of data transmission on the port hence causing the initial network logon to timeout.

Hope this helps.

by carlosh

Thank you so much!!! We have had this problem for so long. and you had it right on the dot. We have a catalyst 4000 and of course the default for the spanning tree portfast was disabled, after enabling it the problem dissapeared. Thank you!!!

by Former member

Answer two is pretty farfetched. Portfast is not enabled by default and you say it happens with all PCs. I would suggest that it is a problem gettting to your DC (Domain Controller(S)). First I would look at your WINS setup and be sure the server are registered to it. Then I would look at the network and notice any other slowdowns, then look on your DCs themselves

This discussion is closed to new replies.