Discussion Locked

No Self Ping

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have one workstation on a Workgroup that was working fine until an update was installed. Now it CAN access internet through a router - but CANNOT access any other local Workgroup resources (says network is inaccessible). Can ping the router - but NOT any other workstation in the workgroup and NOT own IP address. Loopback address (127.0.0.1) DOES ping. It is running XP Home - all other workstations running XP Professional.

Tried reinstalling network drivers - same behavior over wired and two different wireless network adaptors.

Is the TCP/IP stack corrupted? Have tried to reset the stack as here: http://support.microsoft.com/default.aspx?scid=kb;en-us;299357 but no effect.

Any suggestions welcome!

9 replies

by 3xp3rt

Have you tried remove and add TCP/IP protocol?
If not, go to network connection, uninstall the TCP/IP protocol, press Apply.
Reenter, at network connection properties, press install, protocol, TCP/IP.
After installing, set the IP Address, Mask, Gateway, and domain.
Good luck!

by quick\help

1. If you're running Domain configuration; you must change to Pro.

2. If no domain; you have to input values for you network again, Name, etc..., plus check netmask, IP, and check security settings in that PC network configuration, they may be different from the others.

by p.j.hutchison

You probably have IDCMP disabled on Network Connection:
1. Open Properties of Network Connections
2. Open Properties of Local Area Connection
3. Click Advanced, Settings, Advanced
4. Click IDCMP settings
5. Enable 'Allow incoming echo request'
6. Click OK twice

by neiltrevett

ICMP was indeed the problem - but it was disabled in the Norton Firewall - but this was an invaluable hint - thanks!

This discussion is closed to new replies.