Question Locked

No signal after new graphics card is tried and taken out.

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've seen threads with similar problems but i couldnt see any clear answers so here it is.
Put a new geforce 8600gt in this morning, neglecting to remove any of the drivers from the onboard-graphics that my comp was using. No signal. Realised what I'd done, removed new card to disable the previous display adaptor thing, but there was still no signal.

Sorry if this one comes up all the time.
Any help would be much appreciated.

2 replies

by mjd420nova

I've seen quite a few of these lateky and it's a tough fix. Sometimes the new video cards draw a bit too much power from the system boards and this will vaporize traces and cause a multitude of power connections. The first is at the AGP, PCI or PCI-e connectors where the card plugs into the system board and the other is at the power connector for the power supply connector on the system board. Also any number of capacitors could have taken a hit from this increase in needed current. A good close look at the system board could reveal some causes and maybe all you need is a trace replaced or a connetion resoldered. At one time I used a test bed for testing video cards and had a problem with some cards making too much smoke and had to install small pins and pico fuses to protect the testing board from these kinds of faults.

This discussion is closed to new replies.