Discussion Locked

No tone at the other end?

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Having problems with a wkstation. Using a tone generator on cat5 I find that the tone will not transmit through the cable. The connection from the nic to the cable is good except that when trying to create a profile for a user it locks up and I have to end task. If I set up the profile on C:\my documents\fsmith.pst I have no problem.
It's when I try to use our netwk drive I have the problem. I do have access to the internet, and when I log in I see all of the drives showing. It seems as the problem is with the netwk at that location. When I try logging in from another station with the user's profile I have no problem.
It's only at the other station when I have this problem.

1 reply

by syadm

First check that the NIC:s in both ends run at same speed and that the cable used is of the right class and not pinched ,folded ,pressed or such. Any hubs on the way should also be checked for speed and connectivity.
Also check that protocols is same at both ends.
If all this is ok and you still cant reach the network drive then you can do the following to find whats wrong:

Borrow another workstation and temporarily put it in the place of the machine that is giving you trouble. If it performs ok then cabling is ok and you have isolated fault to the original workstation.
If not, then replace cable with one that works.
Now if this works -be happy, if not then the fault is off the other end of the cable.
Remember that the "other end of the cable"
is not the remote end - just the nearest network component.

Happy hunting.
/Tom

This discussion is closed to new replies.