Discussion Locked

No Video Display after trying to install new video card

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I tried installing a new video card, I uninstalled the drivers through device manager and it had to restart , so I did and the resolution was all big since there were no drivers.

So after the restart I turn it off and put in the new card, start it up and NO DISPLAY, cant see Bios, tried resetting cmos over and over and only seems to work randomly, tried putting the old card back in and same problem, no display with no bios or anything.

I got cmos to reset 2 times, first time I hit DEL for bios and it just sat there, second time I hit F1 and it actually loaded windows and all but I had to go to work and shut it down, well after that It started the same routine, no display...so Iknow for a fact it works just cant do shit.

2 replies

by p.j.hutchison

Was the old video card an actual card or was it some sort of on-board graphics chipset?
If its an onboard graphics chipset, then you need to disabled it in the BIOS otherwise Windows will think that it is the primary disably before using your new card.

by martin_flegel

I was using a Samsung LCD 226Bw monitor, couldnt fogure it out, so i hooked up my old crt monitor and bios showed up everytime, just changed the settings in bios, installed old drivers and card, then my friend hooked up both monitors and set it to Dual-Monitor and BAM it came on!!!! if anyone else has this problem try hooking up a older crt monitor

This discussion is closed to new replies.