5 replies
by otl
Sounds like one of the drives has stopped working. Unplug the connector to one of them if the other drive works then you have found the offending drive. If not reverse the proceedure and see if the other drive works. If neither could be the secondary IDE controller has stopped working. Normally found it is the drive controller card on the offending drive causing the problem.
Saw this several times, where one drive is trying to access both channels of the IDE conntroller. PC is normally slow to boot (trying to recognize the drive) or if no drive is recognized on the secondary IDE, faster to boot.
by pattyt67
Poster rated this answer.
by willcomp
Before doing anything else, make sure both IDE channels (primary and secondary) are enabled in ROM BIOS setup. For some strange reason, the secondary channel is set to disabled by default in some older BIOSes.
If both channels are enabled, check cable seating on motherboard and drives. The loose cable gremlin may have been at work. Also inspect cable, mice can and will get into idle PCs especially if there are large vent holes or missing card slot covers.
If BIOS and cable are OK, proceed to above suggestions.
by pattyt67
Thanks you that helped and they are both working know after wiggling them a little and making sure they were pluged in.
by pattyt67
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending