Discussion Locked

NT 4.0 PROBLEMS

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I just purchased 3 computers with NT 4.0 loaded on them. I had to add network cards to all three machines and install the networking. On boot I now get an error that when I look in Event Viewer it states: Error 1130 Not enough server storage is available to process this command. Any ideas what this could be?

13 replies

by nert

A sure bet is to (re)install the service pack after any modifications to the network bindings. I make it a habit to re-install a service pack after chainging anything network related. SP6a is the latest service pack from MS.

by aekland

Check hklm\system\currentcontrolset\services\lanmanserver\parameters\irpstacksize. if it is less than 7 increase it to 9 or 11 and see if it helps.

by allan

System Error 1130 has occurred.
Not enough server storage is available to process this command.
"Not enough server storage" is the term that can be confusing ? is it disk space?

No, inadequate disk space is not the problem. Chances are that the cause is the size of the registry has exceeded the maximum size set in the virtual memory settings. The solution is addressed in Knowledge Base article #Q166840, "Err Msg: Not Enough Storage to Complete Operation".

Another possible culprit for getting the 1130 error typically occurs with computers that come from the original equipment manufacturer (OEM) with Windows NT and Service Pack 3 preinstalled. This problem can occur if Windows NT is installed and the latest service pack is installed before any network services are installed. Read the following article for more information.

15427: Server Service May Fail After Installing Network Card.

It is possible to receive an error message "Printer settings could not be saved" alongwith the 1130 error. The following Knowledge Base article addresses this.

Q234530: Unable to Change the Specified Driver for a Network Printer

by shardy

Reinstall the service pack.I just encountered this one myself.I Setup nt,installed svc pck 6a,installed nic,networking broke,same message,reinstalled
6a......everything ok. Incompatable DLL's from nic install.Hope they gave you the svc pack cd? Will microsoft ever start issuing
nt with a higher svc pack included than 3.0?
Its such a pain !

This discussion is closed to new replies.