Discussion Locked

NT 4.0 RAS Modem not working

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I can not dial out with my ISDN Modem using
RAS. The modem works fine with hyperterminal.
The modem script and the settings are ok because it works on another pc.
It seems like Windows NT, does not allow to dial.
I already reinstalled RAS and Modem and applied the Service Pack 5, no change in behavior.

any suggestions ?

7 replies

by wolfgang aschauer

Have you configured the RAS-Connection under Network - services - remote access service for outgoing calls. Try to configure it for outgoing calls only.

by rock ranger

From the command prompt, check for proper TCP/IP stack loading using the IPCONFIG /all (|more). If not loading, suggest you record modem settings, remove all service, and protocols, modem, etc. and restart. Then right click on network neighborhoodto check properties and use the wizard to reinstall the RAS device (modem), RAS service along with the defaults, TCP/IP only as the protocol, and you NIC. Restart and reapply SP. Restart and you should have service.

by gbainbridge

Be sure that you've allowed the user account you're trying to dial with dial out access with the Ras device. I'm not at an NT server machine right now, else I'd tell you exactly how to check that...

I would assume you've already tried this sinceit's the first place I'd look.

This discussion is closed to new replies.