Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Rebuilding an HP Proliant ML370 G1 with Microsoft NT 4.0 Terminal Services. I cannot get the install to find the internal SCSI hard disks. I don't know where to find the drivers that I need to put on the floppy to press F6 during the install. I've checked HP's drivers site and these all seem to be Win32 drivers (useful once I can get into Windows). I checked the DOS area of the ML370's drivers area and there are no SCSI drivers for install either. Is there a generic or specific driver I can download/use to get the NT4.0 TS install program to see my disks? Any help/411 would be great. Thanks in advance.
5 replies
You should find the driver you need at
http://h18023.www1.hp.com/support/files/server/us/locate/7_4307.html#23.
In the bios setup menu you can check out which SCSI controller card is installed in the machine .
You could also try downloadin an older version of the smartstart software (5.X) which should provide support for Windows NT. It is also found on HP:s support website.
Poster rated this answer.
Did you tried the win32 drivers, those should be it, hp might have a strange name to refer to those.
I know I used those when installing w2k (at pressing f6 step).
Success
Leopold
Poster rated this answer.
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
0 helpful
15 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply
0 helpful
2 replies
0 helpful
10 replies
Question Unanswered
i need help in transferring my bulk emlx files
0 helpful
0 replies