Discussion Locked

NT Backup Error Message

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Suddenly for no apparent reason all my backup tapes render an error message,
"unrecognizable data". I can't find anything on this in the Microsoft Knowledge base as to what might have happened. Has anyone else had this happen and what had to be done to fix it. Right now we don't have another tape drive to swap it with and it's a new device that was working only a few days ago and appears to still be working. The power and drive cables are undisturbed also.

3 replies

by greggmichielsen

I also had this condition using an HP colorado 20GB Travan TR-5 tape drive. I was using NT Backup utility. I installed the Colorada Backup II software and have not had any problems since. I am atributing this to using NT Backup utility since no further errors have been generated.
Hope this helps.

Gregg

by chrisq

The only thing that immediately comes to mind is that it could be a permissions issue. Make sure that the account you're logged in as is either the same or has similar permissions as the account that the backups were made under.

Also make sure that you have the rights to the destination/target folder, and the drive itself.

IMO - if your data is important to you, you DON'T want to rely on MS's backup program to save your ass in the event of data loss. While NT's backup may be good for someone with a workstation and a zip drive, in an enterprise environment you should definately consider something in a "real" backup solution (ie: Exabyte, Arcserve, etc). You don't want your job to rely on a MS product working properly.. ;-)

My .2c anyhow..

- CQ

This discussion is closed to new replies.