Discussion Locked

NT hangs after character based mode of i

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am experiencing Setup Failure During Reboot from Character-based to GUI-based Mode. In Character-based mode I have completed setup successfully (with boot floppies and the CD) then told to remove any floppies or CD's then reboot. But the computer hangs right after POST. What gives? Once again your assistance would be greatly appreciated.

5 replies

by allan

Check your bios settings to see if the boot sequence is correct.
I know Compaq servers can/will change sometimes. Especially if you changed the drive configuration. If there was an array,it is probably trying to boot to those drives.

by samuelbrooks

Make sure you are using the correct drivers. If you have SCSI, make sure you do not let the system auto detect but instead use the driver diskette. Also, If using IDE, try different IDE Drive. I have seen some drives that just will not work because NT tries to write information in areas that are possibily marked as bad.

This discussion is closed to new replies.