Discussion Locked

NT not able to "see" Netware Servers

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are having a recurring problem with NT and Netware. We have formatted a Gateway computer, loaded NT. We use 3Com 3C905C Etherlink 10/100 PCI for the network. All Protocols are loaded and seeing the internet, Lotus Notes and NT servers is no problem. When we add Client for Netware and specify the tree or a preferred server no connection is made.

We've now had this happen to 3 different computers, 2 are Gateways and 1 was a Compaq.

6 replies

by steve cody

Most netware clients are configured to autodetect the frame type, but that does not work very well. Try specifying 802.2 and then if that doesn't work, specify 802.3.
Also, of course, make sure that you have NW Link IPX/SPX protocol loaded.

- Steve

by sflores

Changing the frame to 802.3 worked perfectly! This is the first time I ever encountered this type of problem.

by mckaytech

It would be helpful to know the versions of the client and server but from what you've written, I'm guessing that either IPX is not bound to the NIC or that the wrong frame type is being detected.

Also, make sure you have the right client - the Novell clients are OS-specific.

paul

by garetjax

Sounds like a framing or IPX network number issue. Try specifing either 802.2 or 802.3 frames rather than autoselect for your IPX properties. NetWare 3.X I believe uses 802.3 frames and NetWare 4.X and 5.X uses 802.2 frames. It has been a while...

Also make sure that the workstations are on the same IPX network number as the NetWare server. IPX network numbers are analagous to IP subnets.

Good luck...

This discussion is closed to new replies.