Discussion Locked

NT Pagefile

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
What and where would you set your pagefile settings for 512mb of ram and you have 1 drive with 2 partitions, C=1024 D=4096? Also do you set a range for the min and max or set them both the same value?

9 replies

by ale_dev

Set the pagefile on the D= drive. You should set a range that goes for the min 524mb (512 ram +12) and max 1048mb (double the min).

by pvp

That small C drive scares me, but...

If you have the options set to dump and automatically restart on BSOD, you must have a RAM-size paging file on the system partition, or it won't work. That's 523 in your case (RAM+11).

I'd have a second page file on the other partition, the same size. It's better on another physical drive than merely a partition (speed-wise), but the capacity is the same.

In my case, with 256 MB RAM, I have a 267-267 page file on both the C: and D: drives. Obviously, I prefer not to let the pagefile grow, as it may contribute to framentation, and that's a perfomance killer.

NT works best with a total page file size of 2X-3X RAM.

by sysmgr

If you are not concerned about memory dumps during BSOD. You can set all of your swap space to the D: drive.

by loozzinit

I agree with PvP, that first partition "C:\" is way too small, I would given your situation, run out and buy a cheap secondhand, 512mb or 1gig drive to serve the purpose of a Pagefile drive, this is the scenario that I have on my W2k Server at home and it works wonderfully. If its a speed issue I would reinstall, with NTFS, on the full 5gig+ drive..... Hope it helped a little

This discussion is closed to new replies.