Discussion Locked

NT print que problem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an NT server 4.0 with sp6a. 196 meg ram, 800 mhz cpu, 3 ide hard disks (10g,40g, 40g). Spooler folder is on a different partition from the OS. Printing to an IP address on an HP4v printer. Printer is shared on the network. The server is using only TCP/IP for a protocol, pagefile is 2.5 GIG and spread across the different drives.
Problem: One staff person does a batch printing job at the end of every day. The batch program runs fine and the print jobs are sent to the que. Each job isa single page, but there are often 150 to 400 pages being generated by the batch program. All jobs are sent to the printer que and are there waiting to be printed Initially, about 40 pages print, then the printer pauses for 10 minutes. Then another25 pages print with the printer pausing again for 10 or so minutes. This continutes with pauses of 10 minutes between 20-40 pages each time.

I have tried increasing the pagefile, and moving the spooler folder to a different partition. What can bedone to keep the print jobs printing without the pauses?

9 replies

by rabbit_runner

An added note: This server is being used only as a File and printer server. The main job is for printing. The storing of files is an occassional thing.

by dwilcox22

I think the first thing to do is locate your page file on one partition. Page files were not designed to read across partitions. Locate your page file on your smaller partition if you have room. It can operate on the os partition, or you can put it on one of you other partitions, and remove the other partitions, and reboot the system. I am convinced that is you problem.

by dwilcox22

I think the first thing to do is locate your page file on one partition. Page files were not designed to read across partitions. Locate your page file on your smaller partition if you have room. It can operate on the os partition, or you can put it on one of you other partitions, and remove the other partitions, and reboot the system. I am convinced that is you problem.

by rcc

As far as I understand you have LPR printing. I have seen a similar problem before. Here are some tips:
Try spooling the entire job first ("options" or by pausing the printer from the Control Panel) and see if it changes
Setup perfmon (run first diskperf -y, requires reboot) and see how your disk subsystem behaves (Physical disk queue lenght) when printing the same job
Upgrade the JetDirect FIRMWARE on the Printer's Jet Card (to eliminte tcp/ip problems, this is what I found on mine, and the one below)
Verify that your JetDirect card is fully compatible to your network media (some 10BaseT have problems running in 100TX environments)
Run a network sniffer and see if and what packets travel between the client pc, server and the printer.

by rabbit_runner

I changed out the Jet Card, but the problem still persisted. So your answer did not work.
SOLUTION: For my problem, I eventually found that there is a registry setting for a 'timeout' of each LPR port. When I adjusted this setting, re-installedSP6a, and rebooted, the problem has currently disappeared.

This discussion is closed to new replies.