Discussion Locked

NT Server 4 and partition

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

hello,
as I know, the NT 4 boot partition only can support up to 2 GB space, but I saw someone can install on partition that large than 2 GB space, is there different edition of NT 4 Server can do that ?

Thanks.

10 replies

by mckaytech

Actually on the standard NT 4.0, the system partition can be up to 4gig; on NT4, Enterprise Edition, I believe it can be up to 8.

I believe that the 2gig limitation is a limitation of a FAT16 partition rather than
a limitation of NT per se.
paul

by garetjax

NT4 can support a 7.8GB boot partition if it is NTFS and created pre-OS install (with something like PartitionMagic). On a fresh system install, you can have up to a 4GB boot partition. This limitation comes from the NT VFAT partition limits. Even if you select an NTFS partition during the install, the OS must run Convert to change the partition from VFAT to NTFS. Because it starts at VFAT, you get the 4GB limit.

Hope this helps...

by avachon

Hi, the previous answers are correct, but if you are installing nt and you can not go over 2gb, this indicates a limitation of the bios. You would need to flash the bios (upgrade) and then you would be able to install 4gb or the 7.8 if an ntfs partition is available already.

by wayne.maples

Taken from my tip: http://is-it-true.org/nt/atips/atips120.shtml

During Windows NT's boot process, ntdetect.com, uses int13 BIOS function for drive layout information. Because of int13 limitations, ntldr, boot.ini, ntdetect.com and Windows NT's system files must be located within the first 1024 cylinders of drive 0. The int13 functions allow low-level code to read from and write to the drive. These functions use 24 bits to address sectors on the hard disk. The 24 bits are divided into a 10-bit field for cylinder, an 8-bit field for head, and a 6-bit field for sector. The maximum amount of sectors accessible to the INT 13 interface is therefore Cylinders * heads * sectors = 1024 * 256 * 63 = 16,515,072. When the sectors size is 512 bytes, this
calculated to 16,515,072 * 512 = 8,455,716,864 bytes = 7.875 GB.

The above assumes a disk standard geometry with 63 sectors/track, 256 heads with 1024 cylinders. Some drives are configured with 63 sectores/track, 128 heads with 2048 cylinders. The multiplicat

by satnet

No, You can create one large partition through DOS and then format the 2GB that DOS will see. During the install of NT you will convert the partition to NTFS. That is how they got the larger size partition.

This discussion is closed to new replies.