Discussion Locked

NT Server 4.0 Certification Help Needed

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have written the NT Server Cert exam 2 times and have failed by 5% and 8%. I need some new study techniques to help me. I have been through ExamCram, Sybex, and MC Prep Tests, and old transcenders - and am fairly confident I know the material but I each time I took it my deficiencies were shown in separate areas. Each exam I took was adaptive and I'm sure the next one will be the same format. Specifically, I need suggestions on how to breakdown the scenario questions. (I already have Networking Essentials).

15 replies

by ccsbz

You have the data. no two way about!
One of the Most valuable thing i have learned, that never think you KNOW. Don't Think about it and Go this Time, your Good for IT.
I'll be with you.

DJ.

by kevin_b

Break the question into two areas; essential and non-essential info. Usually there is some info that matters; like what groups they are in and what they want to do; other info like names, job titles, etc that may not matter. Check out what the question is asking and see what info matters. That threw me on a couple of questions. I used Que and New Riders books and the cramsession.com and cram session book. I like having two different books on the same info since they emphasize different aspects. lastly, hands-on training is a must. Go thru every exercise in the book even if you know how to do it. Keep it up; you'll get it this time! Good Luck!

by droper

I assume you are talking about ?? with the problem, optional results, required results, etc. IF so, the I conquered them was to create a "T" chart of 2 columns and as many rows as there reults. On the left, R1 where 1 is the first required result and the next one would be R2 and so on. Then, below Rx I would put O1 for the optional results. I read the proposed solution & scenario again and place a check beside each of the Rs & Os. It was easy to answer the question because I just had to count the number of checks.

Example:

R1|x
R2|
R3|x
--|
O1|
O2|x

by newcomb

It sounds like you know the facts, but make sure you read the questions. It's been my experience that when I miss a mark by such a small margin, it's usually because I started to hurry and didn't read the question carefully.

If you know the material, and it soulds like you do, there's more than enough time to read each question. I usually read the questions twice, select an answer, then read the question once more before commiting my choice.

Go get 'em

by triple7

Write down the required and optional results. When you read the proposed solution you should be able to mark off what requirements have been met by the solution. You have all the testing and reading material you need to pass the exam. Good Luck

by gre.conroy

You should take wks. If you took serve twice already take wks and then svr they are not much difference between them.. A good place to study that helped me was the braindumps and the cramsession websites try them out i got a 900 on my svr exam and a866 on my wks. Also study the transenders there are a big help.. GOOD LUCK!!!!

This discussion is closed to new replies.