Discussion Locked

NW5 server locks up, no response, etc.

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Server NW5.0 with Service Pack 4.0
Hardware is Compaq Proliant 1600 with latest BIOS. Server locks up completely, no keyboard input, can't change screens, if lockup is on monitor screen, uptime counter stops incrementing. All users lose connection. Server seems to lockup in the AM, about once every 2 days.

5 replies

by dcassat

I believe it's a hardware issue. I would check the following:

Outside interference, slight power flux - is there a large motor or say a copier that is started everyday?

Is the battery backup working properly?

Is the server on a dedicated power circuit?

Then I would replace the power supply

Simplify or replace RAM.

One other consideration would be that the keyboard cable is injecting interference on the system board. I have seen this before.

Good Luck.

by phigg

First off, upgrade to the latest SP, SP4 is a disaster waiting to happen. We had the same problems ! Like NT4 w/SP3, no NW 5 server should be runnning less than SP5 in my opinion. SP 6 is better still.
If you still experience problems, it could be hardware. Usually, if you are unable to even get to the alternate console, you have a hardware problem - but again, upgrade the service pack first. it could be a bad filesys.nlm in SP4.

This discussion is closed to new replies.