11 replies
by saihib
by sumner
by ann777
You don't have to remove tcp/ip or your nic. Just go to Control Panel, click on Network and on the General tab you should see a "File and Printer Sharing" button. Click on it and check what you want to enable, uncheck what you want to disable. You will need to reboot though.
by shanghai sam
by reverendzero
I'm not a real techie, but here's a tip anyway.
I enabled file and print sharing on all my stations, but I unchecked the file and print sharing binding in my TCP properties. Then I installed NetBEUI, and bound sharing to that protocol instead.
Now we can share and print internally, but there's no external access to our files since we're using a non-routable protocol.
Hope this applies to your situation...
by sumner
by reverendzero
Hmmm, I'm afraid my experience is limited and I've never seen that message. When I installed my NIC and protocols, it never prompted me. But like I said, I just use basic stuff; no Wingate, ICS, etc. Just a basic idiot-proof Netgear router.
Sorry I can't help. Good luck!
RM
by shanghai sam
by richard lane
For your DSL connection and LAN NIC connection, do you have separate instances of TCP/IP loaded (should show up as TCP/IP LAN Adapter, and TCP/IP DSL connection, or similar)? If so, unbind the file sharing from the DSL instance as suggested in a previous answer. This will deny the DSL connection access to the sharing. hen you want to re-enable it, re-bind it. This will however require a reboot, which is something that, unless there are any third-party utilities around that can do this, you will have to do whatever the solution you choose. This is because the settings that you change at this level for the NIC or other networking connections are only reloaded at boot.
Hope this helps
by shanghai sam
by sumner
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending