Question Locked

Overclocking - Voltage

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hey,

I am currently running a C2D E6600 2.4 on an Asus P5N-e SLI, And im working on Over clocking it. I am relatively new at the whole idea. I have it clocked at 1422 FSB at 9x, 3.2ghz, and I want to push it to 3.4, but im afraid I cannot do that without Changing the voltage, but Im not sure how to go about doing that. Any Tips/Advice would be appreciated.

Thanks,
Jeff

3 replies

by liame

Well you have a pretty big overclock already... if it is stable I'd rest on mt laurels!

Voltage adjustment is done in the bios and whether or not its available depends on the motherboard you are using. Be careful and go slow when bumping up voltages as there is zero warranty cover on chips that have been cooked this way. Bear in mind the memory, not just the cpu may need extra voltage to get here you are going and extra voltage means extra heat so don't skimp on the cooling of the cpu, memory and motherboard - many people forget about the last two with predictable results.

Good luck.

by mjd420nova

There are a million sites to guide you in overclocking, check it out on GOOGLE. Keep in mind that raising voltages may cure instability but you're also boosting the voltages to all the other chips on the board and they will not handle the extra voltage. If it's stable now you're better off leaving it as is before you have to buy a new motherboard after sending smoke signals.

This discussion is closed to new replies.