Discussion Locked

Pagefile in XP keeps growing

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This one is straight forward. I have an XP pro system that progressively uses a larger and larger page file. It starts out around 83 MB and slowly crawls upward until the machine doesn't have enough memory to even shut down.

This happens while the system is sitting idle, with nothing running except the default services, Norton Anti-virus.

Only answers. Don't give links to Microsoft. And don't suggest increasing pagefile size. Thats not a fix. Its a band-aid.

Brian

9 replies

by deadly ernest

A couple of points, the page file will grow as the system transfers information from the RAM to the page file as it needs the RAM and the stuff in the RAM has not been referred to lately. Thus the page file will always be growing.

I assume that you have the system set to empty the page file upon loggin out in the 'Policies' section, if not you should do this.

You need to check for programs that are running in the background and constantly calling upon the RAM, have a look at what is running through the 'System Information' section in 'System Tool' in 'Accessories', and while there check the 'Start Up' programs list and see what is not needed. Anything that is NOT NEEDED should be stopped from automatically running.

by brianaaa12

There was a file called hph050.exe that kept growing in the amount of memory it was using. I disabled from registry and all is well.

by power natto

The default setting allows for file sizes as required making for a dynamic file management and this can be problematic on some systems - try setting the Maximum and Minimum file sizes to the same value (2.5 times physical RAM size is often recommended).

You might also try moveing the file to another (smaller) logical drive to see if that helps; if not, I would go for a fixed Max/Min values there as well.

by timthetoolman

It sounds like this is more a test than a question! :-P

Use performance monitor and log for a few hours. You'll need to add pagefile usage obviously but I'd just add all of the memory counters along with the process counters. Analyse the results to see which process is the problem... and take it from there.

If you're not happy with setting up performance monitoring with logging, then post back here.

by brianaaa12

YOu passed! I found the culprit using taskman. I didn't mean to be so "firm" with the question but I've been a tech for 12 years and don't need directions on how to reformat, get to MS's site or other "non-answers". Thanks again. A+

by thechas

Well Brian, it sounds like you have a memory leak.

Can you identify a software or update installation just prior to this behavior starting.

You can try removing the software or update and see if the problem goes away.

Personally, the only way I have been able to fix memory leaks is to perform a clean installation of Windows and avoid the software or patch that caused the problem.

One band-aid that can help is to install a memory manager.
Of the few that I have tried, memturbo worked the best.

Now some comments on page file settings:

There is a lot of outdated advice on page file settings.

Myth 1: Set a fixed size page file.
I NEVER set a fixed size page file.
When you run out of virtual memory the system crashes.
More and more software requires large amounts of virtual memory in addition to a healthy amount of RAM.

Myth 2: Set the page file to some multiple of installed RAM.
The problem here is that the less RAM you have, the more virtual memory you need.

I myself set aside a drive / partition of at least 2GB and let Windows use the entire drive for the page file.

Alternately, you can get the "benefits" of a fixed page file without restricting the size of the page file by setting the page file to a "reasonable" minimum size with no maximum.

For more reading on this, check out the article on page file settings posted at www.aumha.org

Chas

This discussion is closed to new replies.