Discussion Locked

Palm T3 Digitizer alignment

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My T3 has jusd developed an annoying trait - the digitizer in the Grafitti area is miss-aligned and it and I have to tap about 1-2mm below the item I want. Similarly,in Grafitti the pen strokes appear 1-2mm above the stylus.

I have re-callibrated the digitizer to no effect. I can mis-callibrate the digitizer to correct the problem in the Grafitti area but I then get the opposite problem on the rest of the screen! (Aaagh!)

I have tried a soft re-set to no effect. Has anyone any experience of this and, better still, a solution?

Many thanks.

4 replies

by lyon_bleu

A little over a year ago I asked a similar question--see "T3
Digitizer Mayhem." It seems to be hardware-related, and is likely
the reason the T5 doesn't slide open like the T3.

Other than replacing it under warranty, the only work-around I
could find was to mis-calibrate using the top of the target
instead of the center, with the same results you have
experienced.

Peace,

paul

by upnorthyukon

I had this problem on my Tungsten T3 and the only fix I found, and it works perfectly, is the PowerDigi program that you can get from palmpowerups.com

I tried digiE, digiMe, digifix and none of them worked, especially when you can't even access the task bar when the tungsten is completely open.

It's well worth the $16.95. It has 70 places to tap on your screen to digitize it perfectly!!

This discussion is closed to new replies.