Desktop

Ask something
Discussion Locked

PcAnywhere and ISDN modem

0 helpful
5 replies

by john

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We are using PcAnywhere v 9.2 and an external BT Speedway ISDN TA modem and are experiencing problems.

Although the modem, PcAnywhere and the line seem to be functioning ok, when anyone tries to connect up to the PC they always get the 'busy' signal at their end.

There is probably something I am doing wrong within the software setup, so any help would be greatly appreciated.

5 replies

by saihib

1 Check ISDN via CAPI 2.0 in the Connection Info property page of the connection item. Uncheck the mark next to your modem and make sure all other machines are set to CAPI 2.0

2 Click Details.

3 Check Attempt Channel Bonding if you want pcAnywhere to use two B channels for the connection. The connection is made using one B channel if the second channel is not available at the time of the connection.

4 In the Seconds to Wait After Dial box, type the maximum time pcAnywhere allows for a successful connection after a number has been dialed.

Copyright ? 2000 Symantec Corporation

by estebandelatorre

Check ISDN configuration in the Connection Info property page of the connection item. Uncheck the mark next to your modem and make sure all other machines are set to CAPI 2.0 (both extremes).
Hope it helps!!

This discussion is closed to new replies.