Discussion Locked

Point to point data only connection

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Our company is looking to move our sales force into another building away from our corporate office.

We will be setting up a Point to point Data only connection between the corporate and new satellite office.

What is the best way to accomplish this? ie. equipment to use.

Thank you in advance.

12 replies

by red neckerson

Personally I need more info.
Dept. size, Corp. size, what type of resources are you sharing, and distance.

by frostyptr

more info:

small company: (75-120 employes)
dept to move size: (approx 25 employees)
resources: access to application server (company CRM/accounting program, email, file sharing, etc)

distance: around 20 miles.

by mckaytech

You have a couple of options but with the situation you've described, either a point-to-point leased line or a frame relay circuit would seem most appropriate. For 25 users, I would recommend a full T-1 if it's economically feasible or the highest speed fractional T-1 otherwise.

As far as the equipment, on each end you would need a router and a CSU/DSU. No need for anything particularly fancy - many of my circuits in similar circumstances use a Cisco 2500-series router with an ADC Kentrox DSU. If you want to go upscale a little bit, you could go with something like a Cisco 3640 with a DSU module plugged in.

But however you do it, you need to terminate the data line (the CSU/DSU) and you need to route the traffic (the router). And, of course, you should also build power protection (UPS) into the budget so the router and CSU/DSU are both protected adequately.

paul

by nskharade

I think the if if is only for data transfer, I think a line of 128k is sufficient. Connection can be done through NT server if u have one.

by jolly roger

If DSL is available in both locations, I would consider a DSL VPN connection, especially if the same phone company serves both locations.

by grandspy

I would suggest that you get a Frame Relay link from your telco. On your part, you need to have two routers. Usually your telco will provide the Frame Relay Access Device (FRAD) and install it for you at both locations (corporate and site office). Connect the router using its V.35 port or whatever interface that's available on your router to the FRAD. Your telco will figure out how to connect those FRADs together - fibre, VSAT, SST, etc. Let them decide.

It's quite difficult to suggest the bandwidth requirement, however, it's safe to start with 128Kbps with 0 CIR (Committed Information Rate) for a trial period of 1 week or so. If it's too slow, start increasing the CIR (up to 64K). During the trial period, ask your telco to provide a traffic analysis report. This should tell you your minimum bandwidth requiement and Frame Relay parameter configurations (CIR, Bc, Be, etc.)

Don't worry if you don't understand what the heck are they but your telco should be able to fine tune your connection to your needs. Among other things, you will be charged on the bandwith and CIR.

This discussion is closed to new replies.