Discussion Locked
0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My connection Icon in the sys tray is telling me my port speed (cpu to io port), I want the connection speed between My modem and the ISP. Anyone know how to change that in Win2k Pro?
12 replies
by s_pat_p
by 1ronman
thanks, I had already found and used that site, but thats not what I want to do. I want to hover my opinter over my connection icon and have it tell me what my connction speed is.
by rcube
When you install a modem, the default speed is the highest speed w/c is 115kbps. The connection speed would depend upon your ISPs receiving modem. If your ISP only supports 33.6kbps and your modem is 56k, the highest speed that you could obtain is33.6. Unless, you want the connection to be slow, you could set up the modem speed to 9600 or less under control panel, phone/modem properties.
by 1ronman
I think you missed my point. The default speed of 115kbps is your port speed (speed at which the cpu communicates with the I/O port), this is not the same as the connection speed, the rate your modem negotiates with your ISp's modem.
by 1ronman
Point value changed by question poster.
by beeba
ooh, i've seen that happen.
possibly you may be able (with AT commands) to set a register within the modem to enable more verbose answers...
hrm. i've found the list of entries in the registry which covers the range of connect speeds... looking for a registry value to change to enable them.
by 1ronman
Poster rated this answer
by jmulvey
Strange. I run Windows 2000 Professional and my connection icon *always* reports the actual connection speed. Sometimes I connect and it says "Speed: 46.6 Kbps", and if I'm unlucky is says "Speed: 28.8 Kbps" .. etc... I suspect this is a modem setting or feature. FYI I am using a ZOOM internal modem.
by 1ronman
Poster rated this answer
by jmulvey
Hmm... did a little more research.. check out MS Q article Q227695, it confirms that some modems (ones with poor INF files) will not give you the right speed.
by 1ronman
Poster rated this answer
by 1ronman
This question was closed by the author
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
0 helpful
15 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply
0 helpful
2 replies
0 helpful
10 replies
Question Unanswered
i need help in transferring my bulk emlx files
0 helpful
0 replies