Question Locked

Press F1 To Continue, Press F2 To Enter Set Up (But I don't want to)

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When my server boots I get the

Press ctrl-e for BMC setup...

..and then..

Press F1 to continue press F2 to enter set-up

This server is worked on a lot remotely and I'd like to know whether it's possible to skip this message and just have the thing boot.

I've researched this quite a bit and there is no clear answer out there.

Would anyone know how I can have my server boot seamlessly without babysitting it?...I would like to be able to reboot remotely because we're loading/configuring virtual machines and loading software onto them and we keep needing to re-start...

Thanks for anything.

2 replies

by bfilmfan

In the Bios setup, there should be a choice for disabling the F1 boot prompt.

I know there was on the older Compaq and HP systems.

This discussion is closed to new replies.