Discussion Locked

Preventing collisions on a LAN?

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi there,

I have 2 10/100 3com Superstack hubs that uplink to an Intel 10/100 switch. Network performance is pretty good, exept I have noticed when I am running the service packs for the PC's off a server, I am getting a lot of collisions through the uplink port from the hub to the switch. Both hubs are experiencing this behaviour.

Also, I am noticing that the uplink only runs at 10Mbps, whilst the rest of the ports are at 100.

How would I get the uplink ports to run at 100Mbps andreduce the collision rate during large data transfers? Is it a duplex issue? Or should I connect a second uplink to each hub?

Any ideas would be greatly appreciated.

Thanks again!

Peter

3 replies

by tmaclennan

Sounds like your switches/hubs are autonegotiating incorrectly. You should lock the ports into 100/full duplex. And you should be using a crossover cable.

If both are running full duplex there won't be any collisions.

by peter bate

Hi,

thanks for your input, but I tried the 100/duplex thing and that didn't work.

I eventually just tried different settings and found that half-duplex worked?!? Maybe these hubs don't do duplex.

Who knows, but thanks again!! : )

This discussion is closed to new replies.