5 replies
by hal 9000
Well firstly forget about the idea of reloading the system I think you will find that you have a Printing Priority issue with your setup.
Somehow the computer connected directly to the printer has been given a low priority for printing jobs so it is sitting at the back of the print Que and is going through quite a few checks of the print spooler before it is allowing the machine it is connected to to print.
I would start out by looking at all the printer settings in the Printer window check the priority under the Advanced Tab for starters it should be showing 1.
Lets know how you get on.
Col
I had a printer sharing problem recently where a company upgraded from Windows 98 to Windows XP. In one of their offices four Kyocera 3830N printers were shared and connected with the parallel port. First thing we realise is that the printing takes ages to start on the client PCs and then the users start complaining that they cannot print at all. The limit of 10 concurrent connections had been exceeded.
After I plugged the printers directly into the LAN and re-installed the drivers, pointing the printing to the IP address of the printer instead, the delay caused by a combination of SP2 and numerous port 139 connections disappeared.
This does not exactly correspond to your situation, but if your printer can be networked,instead of being hosted on the XP, by all means do it.
by neil cotton
This can be slightly different for each printer, please check your manual or website for your manufacturer.
In Windows XP
Start>Printers and Faxes>Properties>Advanced>Spool Print Documents > Make sure that "Start Printing Immediately" is selected > and "Print Spooled Documents First"
Hope this helps
NC
by sdkslipknot
by spidershrek
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending