Discussion Locked

printing problems

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My HP 940c shows my ink cartridge to be full yet won't print any colour whatsoever. I have tried 3 carts and the same problem but on the forth no problem at all. As i buy in bulk (6) could it be the ink pad has dried out. Is there sny way to draw it through.

1 reply

by jbrare

Are you buying original HP cartridges? If so, I would return them. HP has always been very good about their products. IF you don't have original cartridges, it gets a little more complicated. Ink tanks come sealed, as well as having the nozzles covered with a type of tape. If they have dried out, and you can't return them, this will often work but it is NOT recommended by HP. Bring about 4 tablespoons of water to a boil. Boil the water in a small stainless pan so that the level is about 1/2" high. After it comes to a boil, remove from the heat source and add 2 tablespoons of 78% Isopropyl Alcohol. Place the cartridge in the pan, and let it set for about 1/2 hour. Let it dry completely on a paper towel. Then install the cartridge and try it. I have over a 50% success with this, so it is worth trying.

This discussion is closed to new replies.