Question Locked

printing to dot matrix printer from clipper 5.2 program under win-xp xp2

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have Clipper 5.2 compiled program that is running under win-xp sp2. when printing to a Dot Matrix Printer, some lines at the last do not print at a stretch, it waits for some time(10 seconds or so) and prints the balance portion. If another printing goes then the previous printing completes and again some last lines wait for some seconds (10 or so). If no other printing is there then after 10seconds or so printing completes.

I write like this : -

set devi to prin
.
.
.
.
@x,y say "....."
.
.
.
.
set devi to scre
set prin to
.
.
.

4 replies

by Former member

http://www.grafxsoft.com/2clipper.htm
Scroll down to the bottom of the page, you will see the link.

Please post back if you have any more problems or questions.
If this information is useful, please mark as helpful. Thanks.

This discussion is closed to new replies.