Discussion Locked

Private IP addresses of different networ

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have several lans situated in several remote locations. We wanted to connect these lans with RAS to our Head Office NT Server! Different LAN uses different IP Network address. The model is as follows:

Head Office: 192.168.1.0, server:192.168.1.1
Sales Office: 192.168.2.0, server:192.168.2.1
Factory Office 1: 192.168.3.0, server:192.168.3.1
Factory Office 2: 192.168.4.0, server:192.168.4.1

All servers will use normal dial-up Modems to connect to connect to the Head office server and we are not using any router!

Now if all the servers in all the LANs has Exchange Server installed as mail tranfer agent, then is it possible to relay all the mails from the other servers to the Head Office server through RAS from where the mailswill be sent to the Internet? Will there be a special DNS entry?

2 replies

by fred_e944

Depends somewhat on your Exchange layout. Are all servers members of the same site? Different sites but same ORG? Anyway, you can configure Dynamic RAS connectors in Exch Admin to transfer between sites. The Head Office will need IMS (or possibly ETRN) to send and receive from the Internet. IMS has a dialup connection configuration tab, and you will have to create an appropriate Namespace entry. Replication between servers should take care of DNS in your network, but you may need to have an ISP place some entries (MX records) on its server. In some topologies MX records may be required on local servers if they are running DNS server service.

by mzrahman

This resolves my internal networks mail problem, but I still have to figure out another problem which I actually didn't ask here. I will ask that in my next question :) Thanks.

This discussion is closed to new replies.