Discussion Locked

Problem Setting up SBS client

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After a fresh install of Win98, when trying to run the SBS client setup disk, the program apparently installs the files but exits before running the configuration. When subsequently trying to log onto the network, the client computer reports that "No domain server was available to validate the logon". Also, after running the client setup, the coomputer hangs up when shutting down. This computer previously ran Win95 and connected to the NT server fine. No hardware or connections have changed.Any ideas?

1 reply

by tprinzo

try mannualy configuring the computer to connect, check the network settings, if all is OK, try reloading the NIC driver. I have had the same problem and usally reloading the drivers works. My other trick is to load NetBeui and use that to get theintial logon, then remove the protocol after you have logged on and see if it will work with just TCP/IP

Hope that helps

This discussion is closed to new replies.