Discussion Locked

PROBLEM WITH MODEM CONNECTING TO ISP

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Have PIII, WIN98, Lucent WinModem. Out of the blue have lost easy to get 44k connection to ISP. Now have to have another phone off of the hook in house, or cordless phone turned on to connect at 4K. Have ran phone line to another jack with no improvement. No changes that I can think of, phone line was running thru surge protector. Whats up???

9 replies

by pv2gates

With a Modem you cannot connect in most areas of the US more than 26K. No matter what your system says you are connecting to, as soon as it goes to phone line it is reduced as low as 16K. Your computer may send the stuff out fast but it gets slowed.There are ways you can make you connection say it is connecting faster than it is by hanging the command string but this is just a deception. Trust me, unless the system has actually slowed down, you connection speed is not affected.

by csmith

If you have to have another phone off of the hook to connect, the MODEM can not cause sufficient loop current to sustain the connection.
This is usually caused by a burned resistor in the MODEM. (Burned coil in older MODEMs)
(I assume you have swapped the phone cable from the MODEM to the wall.)
The burned resistor is usually caused by a "worn out" Varistor in the surge protector.
(The Varistors in a surge protector "Burn out" a little with each surge they supress, until they are gone.)
The first test is to swap the MODEM.
Also check the ground on the telephone entrance box. If it is run to the conduit of the meter or breaker box, it can cause the surges.
For highest reliability, MODEMS should have an independent ground on the telephone service box.
Regards, Chris

by ross

Diagnostics indicated modem was fine so I was thinking phone or ISP problem. Your advice led me back to modem, purchased external serial modem, added some memory since I was messing, and working like a dream. Says it's a 57,600 connection right now. Thanks!!!

by frescalus

The most common problem I would check first would have the phone company look at your telephone lines. You could have anything from a chewed up line to a bird squatting and digging it's itty bitty claws through the cable. Most bad connections comeoff of bad telephone lines.

I would also recommend getting something other than a winmodem. Winmodems rely on windows to do the work for them while firmware modems run independantly of windows. Having that winmodem puts some pressure on windowsand causes performance problems. But that's my take on the modem.

Neil

by ross

I was thinking this way but turned out to be modem. Had me stumped as windows diagnostics, Norton, an modem doctor said modem was fine.

by danpiers

The answers above are all fine, but I'd like to put in my two cents worth. I run a repair facility and we replace many modems. The Lucent variety of the Winmodem is one of the most problematic of the modems. I believe that your modem is shot and needs to be replaced and also recommend you stay away from another Winmodem. As for your surge protector, they are really ineffective after about three years. I tell all my customers to use an indelible marker to write the date of service on their surge protectors. After two years, replace it and use it in a less important job. It's cheap insurance. Additionally, the surge protector for the modem will not give you protection from surges induced by nearby electrical storms. For the most protection, disconnect your modem from the wall when a storm come in. I have many customers who have learned to keep their modem disconnected until they need it, then disconnect it when they log off. They report back to me that they are happy they haven't had to replace a modem in years.

This discussion is closed to new replies.