Discussion Locked

Problem with new Video Card

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I was installing an Xtasy: Radeon 9200 (PCI) video card in a friends computer yesterday and ran into a problem. He is running Windows 2000 Pro and when I insert the card and plug the monitor into it. Everything goes great during boot until the end of the Windows 2000 loading screen and everything freezes.

If I leave the card in and attempt to boot with the monitor connected to the onboard video no image appears.

When I boot without the card in the machine and then insert it while in windows 2000 to attempt to recognize the hardware, the system freezes.

As far as I can tell the card should be compatible with the system hardware and OS.

What do you think should be the next step?

Thanks...

5 replies

by cg it

hummm if you boot without the card do you get to the log on screen/desktop? also, you should never ever never attempt to insert a device into the computer with the computer running to quote you... "When I boot without the card in the machine and then insert it while in windows 2000 to attempt to recognize the hardware, the system freezes". If you did that, chances are you damaged the card.

Now if you have onboard video and it is enabled, you have to disable the onboard video. With a PCI card AND onboard video enabled you'll have a conflict [which would account for a system freeze]. If you haven't damaged the card by inserting it with the computer on, and it's not in the computer. Boot up and enter your BIOS, disabled the onboard video. Save the changes and then turn OFF the computer. Insert you video card, plug in the monitor and THEN turn on the computer. You should have video if the card is not damaged and be able to boot to log on screen/desktop where the new hardware found installation wizard will run. Make sure you have the LATEST ATI drivers for your card. Old ATI drivers were notorious for having problems with W2K/XP [but since have gone to really really GOOD drivers but you need current ones].

If you don't have video, chances are you damaged the card when you put it in with the computer running.

by theohkm

Try to go to safe mode. Remove the drivers and get the latest drivers. Try also to put your card into different PCI slot.

by thechas

The root cause of the system freeze problem is that Windows is attempting to initialize and use the driver for the on-board video.

As D.R. stated, NEVER plug in a computer card with power ON!!!!

It is even good practice to turn off AC power, or unplug the power cord as an ATX system ALWAYS has some power on the motherboard when power is connected.

Assuming that you have not damaged any hardware, what you need to do, is:

Boot up without the new video card.

Enter device manager and remove the existing display adapter.

Shut down the PC.

Install the new video card.

Boot up.

Windows should now boot into a low resolution display setting, and prompt you for the driver for the new video card.

Chas

by jhewitt1103

Thank you all for your responses. Disabling the onboard video in bios and then inserting the card worked. I must of had a brainfart on this one to not have thought of that first. Thanks again...

by sysengineer

You probably fried the video card trying to insert it while the machine was running. But...
I would start by removing the video card and re-booting the computer to see what effect that has.
If the computer boots successfully disable on-board video in the Device Manager. Also, make sure that you have the lastest and greatest drivers for your card. If you can get the computer started up with the new video card and are still experiencing problems, trying use the Direct X Diagnostic Tool (Start > Run > dxdiag) to troubleshoot the device.

Hope this helps.

This discussion is closed to new replies.