Discussion Locked

Problems with Switch?

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a 10/100 Ethernet switch which is having problems. Ping times from workstations vary a huge amount - 1ms to 400+ms to even timing out.

There is not much traffic on the segment but sometimes we can't pull data at all. The server can ping the switch with similar results and shows at times many packets are being dropped.

What causes a switch to drop packets like this? Why would it change suddenly? Hardware failure?
If the switch is failing, can it be repaired?

HELP!!!!

5 replies

by jereg

You don't give any details about the switch, mfr., number of ports, etc., so this is just general info.

Have you tried rebooting the switch?
Have you tried swapping the cables, like the server, to another port? Did anything happen?

If you've tried some of these basics, and you have an older switch, it may be bad.

With the changes in technology, it's probably more cost effective to just go ahead and replace the switch. You should be able to find an unmanaged switch for well under $500.00.

Good Luck.

by wolfbanes

Yes I reset the switch, changed cables and ports. I disconnected all items excluding the server and a workstation.

The switch is a Digital Managed Switch 8 port 10/100. Both the server and the workstation experience the slow connection and time outs when pinging the switch.

by alpha-male

This is a perfect example of what you should use a packet sniffer for. I use Sniffer Pro, but you can download Ethereal for personal use free....and it's truly an excellent product.

If you are not familiar with packet-sniffing, go to www.packet-level.com and look through the examples, help files, downloads etc. I am not affiliated with them in any way, but have learned a lot from the site and Laura Chappell's books.

What you are looking for in particular is the type of errors being generated (Jabbers, CRCs, etc) and anything that stands out - in this case most likely packets with a high "Delta-Time". See what's slowing things down and getting dropped. Once you know what you're up against, then proceed.

One last thought. You said you are using a Digital Switch. I love Digital hardware myself. If you have used the management software to configure the switch, you may want to see if you can still access it and double check the settings. If you see anything out of the ordinary or have problems connecting (due to the dropped packets/errors) get a null modem cable connected to the console port and clear the data. Re-flash the switch's NVRAM to factory default settings and then reconfigure it. I've seen this help before...

Good luck!

This discussion is closed to new replies.