3 replies
by dmiles
by wcp
If your processor is damaged so the computer does not boot.
If this is what you meant, you need the following known good components.
1. Motherboard (MB) that is compatible to the CPU,
2. RAM,
3. Video card unless the MB has on-board video, and
4. Power supply
Make sure the Front Side Bus (FSB) of the MB matches or sets low to that of CPU. Of course, you may not be able to do this if the setting must be done in BIOS. You need to clear the CMOS by setting the jumper accordingly. This is necessary because, for example, if your CPU is AMD XP 2000+ (133MHz FSB) and the MB FSB was set to 166MHz, the system would not boot.
Install the CPU to the above and if the system does not boot, you conclude the CPU is bad.
If the system boots then your new MB may be bad assuming the MB setting was done correctly.
by wlbowers
When I have a processor that will boot but I am not sure of its health I use a system diagnostic/burnin program.
Do a google search on the following:
self-booting pc diagnostic
I got 964 hits.
Lee
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending