Discussion Locked

Proper thermal management...

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Can anyone confirm with me the proper way of controlling air temperature inside a computer??? Aren't you supposed to suck cool air through the front and blow hot hair out the back via the P/S fan or chassis fan? Some cases might not have a fan sucking air in at the front, but it certainly will blow hot air out the back via the power supply, creating a vacumm so cool air can be drawn in the chassis via holes, etc... right?

Then WTF is IBM doing with the IBM PC 300GL sucking air from the rear into the P/S, then blowing all that hot air directly onto the CPU with no chasis fan to suck the inside air out?

No wonder why both my IBM PC300 GL started to fail after about 3 months use. I can't believe the wackos who thought of this.

Just thought I'd share that with you folks.

8 replies

by mckaytech

Your observation that a power supply fan should normally be an exhaust fan is correct - the theory is that the power supply generates most of the heat so it should have the most direct route to the outside.

It wouldn't normally be like IBM to flyin the face of conventional wisdom.

Just a thought - the power supply fan is usually a DC fan - I wonder if it would run backwards if the power polarity was inadvertently reversed by incorrect assembly(many of the plugs I've seen aren't polarized to prevent that)? Same thing with installing the fan backwards - can be easily done with most designs. Are all PC300 GLs working this way? If so, shame on IBM. If not, still shame on them for their QC.

Or maybe it was designed this way to operate better under conditions of extreme cold (supply waste heat from the power supply to pre-heat the CPU?) :-)

paul

by tchieng

I had to flip the fan around and re-wire it to the 12v source. Runs 10 times cooler now.

by saihib

Here's the basic rule of thumb. Any fan mounted in the back of the case should suck air out. Any fan mounted in the front of the case should suck air in. Answer 1 about reversed polarity is something you should check. Internal fans (ie. those mounted on the MOB or CPU) in general, only have a chip to cool. You should make sure that the exhaust from these fans, if possible, is directed towards another fan that sends its exhaust outside the case. A lot of new computers have air channels built into the case to facilitate hot air exhaust.

by tchieng

Even if you could run it reversed polarity, the fan is design to spin in one direction only for max air flow. I was able to re-direct the fan.

by its a secret

Rule #1 heat will rise while cool will be pushed down. Most case fans are located on the front bottom (intake). most power
supply fans are at the top rear (exhaust).

by bjas

Amazingly, IBM is actually following the ATX standard which specifies that the power supply fan should be an intake. You should be able to reverse the fan but beware of High Voltage charges due to capacitors. You might want to consider just replacing the power supply... the majority have fans that exhaust air.

by tchieng

Would love to replace the power supply, but these PCs are proprietory designs. The p/s is mounted weird. Was able to reserve the fan. Thanks for you input. Wish I could give all you guys points...

This discussion is closed to new replies.