Discussion Locked

Pro's and con's of Novell clustering

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm looking for experiences with Novell 5.x clusters. Not the fancy sales talk, but the true story.

We're a Netware 4 using company and are planning to upgrade to Netware 5.
At the same time we want to introduce Novell clustering.

Up to now Ionly have experience with MS/NT and Unix (HP & Sun) clustering. And those experiences are not very good. It takes a lot of effort from cluster specialists to get these clusters up and running. And every time a update of the HW or SW is needed these specialist are needed also, but they seldom are available.

Is that the same with Novell clustering?
What other pitfalls can anyone tell me (next to the sunshine stories of the vendor)?

Regards,
Robert Kooman
ANWB
The Netherlands

7 replies

by jimbb

I've installed a few clusters, and if you read the prerequisites carefully (servicepacks, client versions and so), and use decent hardware, I don't see any problem. We have both demo-versions (in our lab) as live versions at customers running effortlessly.
Careful with hardware support though. I had no problem at all with Compaq using fibre-channel, but the HP Fibre Channel Assistant for example is a clumsy piece of software. HP can't guarantee that certain of their versions will function properly, or that you'll be able to access your disks again after a disk has been added, for example.
I also ran into a very unusual condition, apparently the full name of the cluster (=treename+context+name) cannot exceed 42 or so characters.

Jim

by ivanr

We recently installed clustering on NW5 and the Dell Powedge servers. It seems to be working fine, although you do have to do your homework in regards to patches and drivers and the like.
As far as support, I believe Novell has tested this on bothCompaq and Dell platforms, so this would be your safest option in regards to hardware.
Cons, the cluster volumes are created as NSS volumes. It is my understanding that these volumes do not support compression. Because of this, you will probably be making a larger investment in hardware.

by ticeman24

I have set up several of the compaq clusters and found that it was fairly easy to configure. You do have to do research on how to set up the resources for some of the programs but if you use any of the popular netware programs you should have no problems. You will need to test the servers and resource scripts before migrating the servers to make sure you have it right. Once you have the cluster setup you can take it down when you want to do maintaince (software and Hardware).

This discussion is closed to new replies.