Discussion Locked

Protocol to use in W98 with cable modem

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 4 computers networked with a 5 port hub in which the cable modem is using the 5th ports uplink. I like to share files and play games over the LAN but not sure on the protocol to use. I have IPX/SPX installed on all, but it just seems slooow. Also, I have to consider the security issue with the cable modem and not have file and print sharing enabled on TCP/IP. Should I have a secondary TCP/IP, NetBEUI or can I do something with IPX/SPX? Some games only use the IPX/SPX protocol on a LAN. Thanks for any response. Fudgstu

11 replies

by udovik

Hi! Tell me more about your hardware and i'm resolve uour problems. I'm need information about your HUB, OS, and LAN CARD

by fudgstu

HUB,OS and Lan card is not the issue. I need to have good secured pc's that I can share files but still be able to play lan games with. Secondary TCP will not help on a cable modem, so that is out of the question. Specifically need info on IPX and NetBeui. What are the pros and cons for each protocol.

by bwarez

Keep it simple. Use tcp/ip on all computers, but have ipx/spx installed on all for those unique games. There are a hundred reasons your games could be slow, ipx/spx isn't one of them. Run a fresh install of those protocols on each pc, also look for the latest drivers for each nic. Get more RAM. Not a real technical answer but it will work.

by udovik

Ok. You must install TCP/IP protocols. Do it for this:
1. Open Control Panell
2. Open Network
3. Press key Add and select from list TCP/IP protocol.
You must do it for any computers connected in Your network. Then You must for each computer his network IP address. This address must be different from previous.
With best regards!

by fgil

Suggestion:
1.Drop Cable Modem use altogether! Get ADSL. Depending on the carrier you use, too many installed nodes are hogging the bandwidth.
2.The standard protocol to use is TCP/IP because it is the only true "Routable" protocol, but using IPX/SPX (which was mainly designed and used for Novell Netware Networks)does not in and of itself depreciate the network ( although I would rather just load TCP/IP by itself).
3.Get an 8-Port 10/100 Hub, and if your NICs are not 10/100, replace them.I have had very good experiences with an increase in bandwidth and response by doing this.
4.There is no 100% security fix, whether you use a software firewall, hardware firewall, or both. In home and small office environments it is just best to just shut down your cable or dsl connected machine at the end of the day, but there are several modem/routers available (with and without hubs)that can help, e.g. LinkSys DSL/Cable Router, Netopia R9100, and others that use NAT, and have a built in firewall(i.e. filter) and DHCP client/server capabilities. Good Luck and let me know if this helps!

by bgriffith

TCP/IP is the slowest, but you need it to access the internet with your cable modem.

IPX/SPX was developed by Novell for large corporations. Good speed for large networks, a lot of unnecessary overhead for small networks.

NetBEUI is designed for small networks. It is ideal for networks with under 20 computers. It doesn't have a lot of extras, like printing, security, etc., but you have TCP/IP for that. Plus, NetBEUI isn't routable, which means nobody outside you're physical network can connect to it.

I've had problems with games and programs when only NetBEUI is loaded, but a TCP/IP and NetBEUI combination is ideal for a home network.

This discussion is closed to new replies.