23 replies
by systemcheck Accepted solution
by cmiller5400 Accepted solution
The CPU is probably overheating at 170F. What CPU is this? It really depends on the make/model for accurate temp thresholds.
I'd be making sure that you have proper airflow in the case (pull in air in the front and push it out the back) some of the fans may be backwards creating a wrong airflow pattern. Also make sure that you have proper coverage on the CPU/heatsink of thermal paste. Too much is bad and too little is bad.
by systemcheck Accepted solution
its the intel e6850 (core 2 duo 3.0 3mb)
dont believe its the airflow was running fine for like 2 years in its previous state just turning on facebook increase cpu temp 20 F.
by cmiller5400 Accepted solution
See the link at the bottom, the operating temp is 41F - 161F. I'd replace the stock heat sink with a more "souped" up one. I saw on a quick Google search that the stock heat sink wasn't sufficient in the posters opinion.
by systemcheck Accepted solution
but these number are with an aftermarket, solid coper heatsink and yes i have applied the thermal paste on correctly and reapplied it correctly (pea size).
also just got phone call that my hdd is acting up now might be from heat dont know.
by cmiller5400 Accepted solution
by systemcheck Accepted solution
by snuffy09 Accepted solution
have you tried putting a fresh dose of thermal grease on your cpu?
are all your fans clean and working ok?
about freezing up, before you said you checked the RAM i would have thought the ram was bad, how did you check the ram? i would swap in a stick that you know works from another system.
Are there any errors in the event log? you could have a harddrive going bad.
if your system has been over heating for awhile now without your knowledge you may have a few damaged components. I have seen small form factor towers that got too hot and capacitors burned/exploded leaving a brown liquid behind on the motherboard... lovely!
by systemcheck Accepted solution
fresh thermal paste have been applied
pc clean, fans operational
ram i do have two spare sticks i can use
nothing in the error log, hdd thought about dont know how to test
mobo doesn't look like it blew up
by ---tk--- Accepted solution
you have a nice aftermarket CPU Heatsink...
Just wondering: do you have speedstep enabled in the bios? also is the CPU fan in the correct slot on the mombo? Sometimes the system will increase/decrease RPM's based on thermals...
(edited: I can't spell today..)
by snuffy09 Accepted solution
On the manufactures website they should supply utilities (boot disk(s)) that you can use to test your hard drive.
Was your system overclocked at all?
***If so, could try setting your mobo back to default settings, sounds like everything's being overworked to produce so much heat.
by oldbaritone Accepted solution
Run it with the covers off for a day or two, with a 10" or 12" box fan blowing on it.
If the problem goes away, your issue is heat related.
If it comes back when you close the covers, you need more cooling - period.
CPU at 170 F is 76 C - which exceeds the maximum allowable temperature. Check the specs for your chip, but you're probably at least 5 C out of spec. That's just plain too hot. Many chips have internal thermal shutdown.
You didn't mention the drive temp, but a WD SATA drive spec is 32 F to 140 F. Again, you're pushing the limit, and probably exceeding it. When the drive heats up, it stops working.
One way or the other, it sounds like too much heat, too little cooling. Get bigger fans, or a new high-performance enclosure with more cooling.
It's easy to check that, just by opening the box and letting it run cooler. You'll know before you spend any money.
by systemcheck Accepted solution
if i remember right hdd runs at 108f
ill try it with the side of the case off and a fan blowing on it, just to remind you this just started happening after 3 1/2 years of running this computer with same spec, then added larger gpu and 8 gb of ram a month ago problem started 1 week ago
by cmiller5400 Accepted solution
by oldbaritone Accepted solution
larger gpu and more RAM usually means more heat in the box. Running OK for a short time (3 weeks) and then having strange failures just sounds suspicious.
Covers-off test is easy, quick and free.
And it's conclusive. If the problems come back with covers on, and go away with covers off, it's heat.
We haven't even talked about the other components, but lots of things "go nuts" when they get hot. And many "consumer" chips are "commercial" chips that don't meet the more rigorous spec.
You can also try cooling spray, but BE CAREFUL with that stuff. Too much thermal shock and the component could crack.
Run it for a week with the covers open - if the problem goes away, you'll know. If not, you'll know it's something else.
by systemcheck Accepted solution
by ---tk--- Accepted solution
I would suggest connecting it to the mother board, so the motherboard can increase/decrease the speed (RPM's) as needed... Might help...
All the other fans I do the same, use a Molex, but the CPU fan I always attach to the mombo...
by systemcheck Accepted solution
by systemcheck Accepted solution
by systemcheck Accepted solution
by oldbaritone Accepted solution
by systemcheck Accepted solution
i believe we may figured it out, Houston were coming home!
Now i just got to wait till my taxes come in so i can purchase on along with a new 800w modular psu
by systemcheck Accepted solution
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending