Question Locked

raid mirror set up

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am setting up a Dell Poweredge 1430sc server wirh SRS raid controller and two sata hard drives. I want to set up a mirror. I used there managed setup disk and selected mirror raid. My question is: I can not see the mirrored drive in hard disk management. How do I know the second drive has been set up and the mirror is working.
windows sever 2003 SP2

3 replies

by hal 9000

You will only ever see 1 HDD as effectively that is all that is connected as far as the computer is concerned.

If you want to see if you have both drives present you need to read the Users Manual to see how to enter the RAID setup and check out what is happening. This generally consists of holding down the [b]CTRL and A[/b] while the system is booting but the Key combination may be different in your case. Then you will be directed to the RAID Array and you can see what is installed. You need to become familiar with this procedure as if you have a HDD Failure you need to know how to replace & rebuild the RAID Array.

Col

by anthony

You shouldn't see the drive in the windows disk management console because the raid controller has control of it. If you get the Dell raid mamangement software installed you can manage your mirror from there. It is designed that way so you don't make changes to the mirror.

Hope this helps.

This discussion is closed to new replies.