Discussion Locked

RAS Callback problem

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have already installed two years now a RAS server on NT that works just fine and with callback options. If i use my mobile phone in order to call the modem pool of the RAS, although the call is correct, on callback the server disconnects the mobile phone call and tries to callback. At callback the mobile phone rings but doesn't pick up the line. In diag logs i see the ATS0=0 line that means that it sees that the line is closed and no callback is waiting. The correct command should be ATS0=1. Although i put as extra command this one at the mobile modem properties, it keeps ignoring it and no callback feature is happening.
Please inform me about.

5 replies

by pvw

Does your mobile shows DATA CALL when your server is calling ? If not, get a DATA number from your phone operator. Usually you have to pay a monthly fee for this.

Regards.

by t.kotoulas

I already do this and on callback i place the data call number but again on receiving the call it recognizes the call as voice.

by pvw

Hi, unless your mobile sees it as a datacall you will never be able to receive any data call's if Voice is on your mobile. You should check the modem from your server. Is this on an ISDN line ? or behind a PABX ?
There is nothing wrong from your mobile site but probably a configuration setting on the server side. (try a regular PSTN modem.)

This discussion is closed to new replies.