Discussion Locked

RAS & DHCP & Internet

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

How do I set up DHCP and Ras to allow internal computers to access the internet.

I have setup RAs to allow out and incoming calls. My ISP has assigned dedicated IP.

DHCP Global Scope
Router: 192.168.31.1
DNS: IP's by ISP
Wins: 192.168.31.2 "server"
Node type: 0x08

I have tried assigning router Ip to Server NIC. Did not work.
In WINS I can't figure out how to setup server for multihomed. It automatically built a unique entry for the dserver and I am unable to edit it.

All internal computers run NetBEUI and TCP/IP
I need some serious help. My client is getting upset.
Please email me if you throughly understand DHCP RAS Wins.
gfreeman@infonetz.com

Gregg Freeman

2 replies

by eshen

2 Nics in the server. Nic 1 connected to the router and it's assigned 192.168.31.2. Nic 2 has internal network address. Install RRAS set default route on Nic 2 (internal nic) to 192.168.31.1

by gfreeman

Ok there is no router persay When you setup DHCP that is what it calls the gateway.
What I don't understand is: If I reserve an ip address in DHCP for the modem.
Then assign a second IP to the NIC for the reserved IP why wont it work. I theory it sounds good. You have been the best answer so far to my problem can you elaborate more.

Gregg
P.s can I e-mail you direct?

This discussion is closed to new replies.