Discussion Locked

RAS & DHCP problems

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We recently setup RAS on our NT 4.0 server in order to setup VPNs. The problem is that our DHCP manager is getting clogged up with (what seems to be) VPN connections and they do not release the IP addresses after the connection is closed. How do Iconfigure the RAS server to release these IP addresses. We keep running out of IP addresses and I have to go into the DHCP manager and delete them by hand. Please help.

7 replies

by bblunden

I think the best solution would be to reserve a range of IP address in your DHCP manager. Then go to the RAS properties and set the same range. That should take care of the problem.

In the alternative, you may want to create a separate subnet for your RAS clients (you mentioned running out of IP address').

Hope this helps.

by jbrody

These directions are totally non specific. I already have a range of 10 IP addresses set up in my DHCP manager. Where does one set up this range that you are speaking of in the RAS administrator.

by mservino

If your running RAS on your Primary Domain Controller I reccomend you switch it to another machine, for starters. Secondly I would set as seperate subnet and DHCP server service on the RAS Server just for remote access people. It means a little more work this way but it can be well worth the effort. Also when you set up the DHCP on the RAS set the leases to only a day or less, how long do you really expect a connection to last? a few hours? a whole day? this will allow you to expand the number of available IP addresses for RAS use, make it VERY easy to pinpoint what they are accessing, keep the access to a short period of time, and keep recycling the Addresses.

by jbrody

I only have one server in the office. Everything has to go on that one server.

by netwill

setup a different range of IP address with shorter lease time for RAS connection.

using AT command to run dhcpcmd.exe (from NT RK) periodically. check with technet

Hope this helps!

This discussion is closed to new replies.