Windows Forum
I have an nt 4.0 server with a usr/3com 56k modem setup for ras. Recently it stopped working!!!! :<
I am getting the following:
Hardware failed
line non-operational
I tried two different servers and three modems. Has anyone ran into this?
Also, I already tried the 32 character trick.
by mckaytech
What is the full text of the error message and where are you finding it (on the console, in Event Viewer, etc.)? Also, are these internal modems, external, serial, USB, etc?
Since you've already replaced the servers and the modems, I would be thinking about anything you haven't replaced (cables?, I/O cards?) or about anything that might have been done around the time it stopped working (firmware upgrade? power failure? CMOS configuration change affecting a serial port?)
Interesting dilemma...
paul
by nrodriguez
it is a 56k ext modem with all new cables and i get this error message in the Remote Access Admin - under port status
** there was no error message in event viewer
hope this is a little more detail
This discussion is closed to new replies.
Sort by Trending