Discussion Locked

RAS + WANs

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What is the best way to achieve TCP conectivity with the following setup.

Domain in London, 2 way trust to Domain in Scotland. The servers only current connection is when the Scot server uses isdn to synch mail.

I need some users in Scot to be able to access the London network via ISDN.

Scotland server is both PDC/Exchange5.5 and RAS. The ras connections all use dhcp.

how can I get the Scotland server to make a isdn connection and allow full routing via this DHCP connection ?

7 replies

by otto3

You'd need to have a routing device on both sites, which can be software or hardware. Setup RRAS for the NT server on both site, There is ample documentation on this subject on Microsoft's site. However, my preferred way would be to use a cheap ISDNrouter. Cisco and other companies have them. They work better than the software solution.

Otto

by mark_lt

same comments to all 3, thanks for the tips, I am going for the 3com units.

I had hoped for a software only solution but it seems a bit unreliable.

thanks again

by dc1

Easiest way is to place a router in Scotland and a router in London. If that is not feasable you could setup a persistent RAS connection between the two sites.

by colin.mcnicol

In similar situations I have found 3Com ISDN LAN Modem product provides a cost effective and reliable solution. This is basically a dial-on-demand router with an integrated ISDN terminal adapter and 10BaseT hub. Setup is simple and the thing works like it is supposed to. The LAN Modem can be configured via a web browser, so remote support is simple. These are also useful for providing local internet access, although you'll want some firewall protection if you do as there's nothing built in.

If you go with this solution you'll need the European S/T model 3C891A. Last time I purchased these they were around ?220 each.

This discussion is closed to new replies.