part2)
Restart from the three setup disks supplied with Windows NT Server.
When asked if you would like setup to detect your mass storage devices, press "S" so that detection is skipped and you specify a mass storage device.
When setup list devices found, which should list , press "S" again and insert the Microsoft ATAPI Service Pack 4 IDE Driver disk and press ENTER twice.
After setup reads the disk and list the Microsoft ATAPI Service Pack 4 IDE driver, press ENTER to accept the driver.
Setup now lists Microsoft ATAPI Service Pack 4 IDE Driver as an installed driver. If you have additional drivers for other mass storage devices, press S; if not, press ENTER to continue through setup.
Setup should continue through normally but, it prompts you to insert the disk labeled "Microsoft ATAPI Service Pack 4 IDE Driver Support Disk" at the copy phase after you have chosen or formatted a partition on a hard drive.
since you have to create at least 2 partitions I would suggest to use the 3 floppies , create 6 GB primary system partition, apply sp6a to see the rest and use the rest as a data medium or what you see fit.
regards,