Discussion Locked

Re-partitioning NT Server

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Our NT server (4.0 SP6a)was setup up by a consultant as follows:

Raid 0+1
Drive C: 517MB
Drive E: 4.88GB
Drive F: 19.9GB

All partitions are NTFS

Drive C: contains NT only, however it is quite full (97%). We'd like to re-partion, perhapsadding some additional capacity at the same time. What's the easiest and most reliable route to take? Has anyone had experience with a product like Partition Magic on an NT Server?

14 replies

by tony.colgrove

PartitionMagic will not install on an NTServer. They do have a server based version called Server Magic, and it works really well.

by ronnonf

All You really need to do is reboot the machine either bootable floppy or bootable version of the latest Pqmagic and resize the drive.

by dkpalmer

Three alternatives.
1. Server Magic installed on server.
2. DOS boot disk version of PQMagic and resize appropriate partitions. But remember that you need to work "down" - i.e. first resize the F partition. Then resize the E partition and "move" it to put the free space to the right of E. Then resize C to use the additional free space.
3. If you have the resources, use Ghost to image the C, E and F drives. Then reformat the drive and move the images back to their respective partitions. Ghostwill automatically adapt to the new partition sizes.
In all cases - BACKUP YOUR DRIVES. PQMagic is very reliable but not 100% foolproof.

by allan

Reply #3 is the best answer.
You don't say if the E and F are actual drives or just partitions
Looking at the size of C: I'd guess it's formatted with FAT file system.
If so, you may want to back everything up and then install a second copy of NTon the E: drive. Change the boot ini to boot from the d: and leave c: for an emergency repair boot that can be accessed with a DOS boot disk. During the new install resize the partitions the way you'd like. Then restore from backup.

by tigre_269

David, in answer #4 is correct mentioning Server Magic. Partition Magic does not work on servers, workstations only. Power Quest's Server Magic was great! I was able to repartition drives on six servers without having to rebuild them. Just take note, read the manual carefully before using it. Ex. Since my company was unwilling to purchase RAID controllers, I had to use NT software mirroring. If you want to repartion an NT software mirrored drive, you need to break the logical mirror, reboot, verify the mirror is broken, then run Server Magic. Here is the link directly to Server Magic for NT. I used version 3.0, it works for NT and Netware.

http://www.powerquest.com/servermagicnt/index.html

Last note, always have a backup ready and/or an image of your drive.

This discussion is closed to new replies.