Discussion Locked

Ready to Exchange 5.5 (and be a hero)

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am an accomplished technician at a medium-sized business with medium NT server experience. It seems as though our mail server is going down every 3 months or so because of virus or a-bends or other unknown hardware reasons. Still, our Exchange admin is reluctant or unskilled in clustering our server to another server ready to work should an emergency arise. The restoration of the OS, the reinstallation of Exchange and restoration of the mail store from backup is the usual procedure for fixinga downed server here (sad I know). How would I create a smaller server that I could have ready to implement when (not if) the mail server dies? I have a decent spare PIII 833 with 256MB RAM, a 20GB HD and is WinNT compliant. I have access to all theserver software, installation disks and administrative privileges. I would rather the server not even be attached to the network during it's installation and wait for the right time to connect to our network. Our current mail server is on WinNT4 Server SP6; Exchange server 5.5 SP3; has 20 shares; and a 17.2 GB HD with 8.6 GB used. This server I would create would be just temporary enough to serve our clients until the real deal is fixed. What would be the best way of configuring this server to be ready and how could I update the mail store every week to keep it up to date?

5 replies

by mark fenwick

If your mail server is not a domain controller and the backup system is of a similar hardware spec, you could consider imaging (ghost, imagecast or whatever) the mail server.

If you can get an image of the mail server on your backup system with the same SID you should be able to just plug it in if/when the mail server dies. You then just need a way to keep the information stores up to date which if you have the same tape hardware should not be a problem.

Bit of a lash up I know, but thenyou did rather rule out Ideal solutions.

Hope this helps

Mark

by hicksdustin

What Exchange Server 5.5 version are you running?

The enterprise version supports fail over clustering, (automatic server switchover), the 'regular' version does not.

I would suggest trying to upgrade to enterprise. Make the point with the powers that be that reliability would greatly improve (and that their costs should be reduced).

The other question is: why not just make your 'spare' PIII the exchange server. If your problems are hardware, you'll find out soon enough.

Dusty

This discussion is closed to new replies.