Discussion Locked

Rebuilding a PDC

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What is the best way to bring down a PDC and rebuild it. I have my thoughts and have heard a few others. I just want to find the fastest lest disruptive way of doing this.. Basicly I need to tear down the the server and rebuild it. I am realy just concerned about saving the permissions on the shares and the SAM DB.

Thanks

5 replies

by ray_elvis

Call me a Wuss, but we thought about replacing/rebuilding Domain Controllers once...once. Instead, we redefined their roles on the network and did a little clean up. Now, they perform no other services outside of the role of PDC/BDC. I don't think you really need a high-end machine to act as a controller. I know that this isn't a REAL answer, but what the hay. I'd have to be pretty desperate to mess with my PDC. If I did, I'd probably just do the old back up, promote the best BDC to coverthe job, take down PDC and rebuild as BDC. Then promote back to PDC. You did not mention an existing BDC in the question. I would not even consider taking down my PDC without configuring a BDC (or two) to fill in. The BDC promoted to PDC will keep all account info in line while the original PDC is away. If it can happen, it will?unless you are prepared, then it won?t.

by bob zinn

to bring down a PDC, bring up another machine as a backup domain controller.
promote it to primary domain controller.
this will demote the PDC to bdc.
you can then brind down that machine and do
whatever you like. When you want to bring it up, bring it up as a backup domain controller.

by andrej.mlakar

Actually I am not contributing a reply to the PDC-BDC discussion. I would like to ask for additional explanation: Is it possible to promote the existing "member" server of the domain to the BDC and then promote it to the PDC? Or do I have to do theinstalation on it from scratch to get a BDC to be able later replace the PDC? Regards, thanks!

by hanmer

That would be nice, oh so nice. Unfortunately this is not possible. During the initial install when you are given the choice of Domain Controller or Member this is where the decision must be made. A BDC will sync with the PBC and get a copy of the SAM when first brought onto a domain. A member merely says Hi How Are Ya, I'm Here.
A fresh install is necessary.

by d.k.

When you installed Windows NT Server, you were asked if you wanted to create a a domain controller (DC). Your choice was permanent. If you declined, you could never create one later (MSDN KB Q193219).
However, there is a utility that solves this problem.

This discussion is closed to new replies.