13 replies
by mstrankay
by interface
by gregc
I agree with the first answer, you did not say what version of Netware you were dealing with. Be sure you have the latest version of Vrepair on your the C drive of your server and, if you have added name space to SYS Volume you will need to load thename space before running Vrepair, be sure it is the latest version also.
1. Down the server and scan the dos partition for viruses.
2. Remark everything in config.sys and everything but "cd\nwserver" and "server" from autoexec.bat.
3. Boot the server with "server -ns -na -ndb" (if NetWare 3.x, don't use the -ndb).
4. Load the disk drivers.
5. Make sure you have the latest version of vrepair.
6. Load vrepair and set the following options:
Write changes immediately to disk
Purge deleted files
At this point, if vrepair still can't see the volumes, you have only the following three options:
1. Restore from backup.
2. Use a data recovery service (for example Ontrack Data Recovery Services).
3. Use data recovery software. Ontrack has a demo
by interface
by stanps
Assuming you have NW 4 or 5, and your volumes are not spanned, you can use the "upgrade mounted volumes into directory" option, in Install.nlm or Nwconfig.nlm.
Hope this helps.
Stan
by interface
by duster52
I agree with everyone else about VREPAIR. You should only reinstall netware if the entire server has completely crashed and you only have backups of the server. There is an option in INSTALL (or NWCONFIG for NW5) that allows you to copy system files. This will restore the SYSTEM and PUBLIC files to the server. However, it will restore them to a pre-patched condition. If you have to do this, you will need to recreate the AUTOEXEC.NCF, re-patch the server, and reinstall any third party products.
I have had to do this when the entire SYSTEM and PUBLIC directories on one of my servers were deleted (no idea how, when, or by whom....)
Good luck
by interface
by miller6010
by interface
Be careful with the mirror set. If you need to break the mirror set, do SOMETHING with it, such as deleting one of them. I have had an instance where a mirror was broken and the old volume was left intact. Much later, after a 4.10 - 4.11 upgrade and several patches, the good mirror died and somehow the system came up on the old volume. What a mess!
Assuming that you have a readable tape with the SYS volume, you can reinstall as a last resort.
1. FDISK and reload the server from theNW CD as a new server.
2. Install the tape software.
3. Mount/Merge the tape and restore the SYS volume.
4. When you reboot, you should be back wiht all the patches in place.
Good Luck.
by interface
by interface
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending